used with the DC cable with lighter plug only to supply AC power to products that require 150W
(120VAC/1.3 A) or less. If the appliance requires more than 150W, use the optional DC cable
clips for battery connection.
• Attach the red ring-type connector to the positive (+) DC terminal (red) on the power inverter
and connect the black ring type connector to the negative (-) DC terminal (black) on the
Power inverter.
• Tighten the nut on each DC terminal.
• Insert the light plug of this cable to the fused 12V lighter plug socket.
• Unit is ready for use.
Connect unit with optional accessories using the Battery clips cable:
CAUTION: Please be sure all the connections are tight before the use of the unit.
• Attach the red ring-type connector to the positive (+) DC terminal (red) on the power inverter
and connect the black ring type connector to the negative (-) DC terminal (black) on the
Power inverter.
• Attach the negative (black) clip to the negative (-) battery terminal.
• Attach the positive (red) clip to the fuse or circuitry breaker of the 12V battery bank as
indicated on ‘Typical Wiring block diagram of the Power Inverter’ on page 5.
• Unit is ready for use.
Testing the Power Inverter:
• Turn unit on by using the On/Off button on the unit. The ‘Power’ light turns on indicating the
Nature Power Inverter is ON. AC output is now available.
• Plug in a small AC load like a 25W table lamp or small appliance to the AC socket to verify
AC is available.
• The unit is successfully installed and functioning properly.
Test the GFCI monthly:
• Use the following instruction to perform a monthly test on the GFCI to ensure the GFCI is
functioning properly.
• Turn unit on and plug a small AC load (40W light bulbs) to the GFCI.
• Check the AC load is ON.
• Press ‘Test’ button and observe a click sound. Check AC load is turned off.
• Press ‘RESET’ button and check the AC load is back ON again.
4. UNIT OPERATION
WARNING: RISK OF EQUIPMENT DAMAGE
• Do not plug surge-protected power bars into the unit’s 120 VAC outlets. The surge protected
components on the surge-protected power bar may not like the modified sine wave output
generate by the inverter.
• Do not connect an AC power source like utility power or generator to the unit 120 VAC outlets.
Turn ON and OFF the unit
• Toggle the On/Off switch to ‘ON’ position to turn unit ON.
• ‘Power’ indicator will turn green.
• 120 VAC Output is available at the AC output socket. (For 38304, 5V USB is also available.)
• Toggle the On/Off switch to ‘Off’ position to turn unit off. ‘Power’ indicator will turn off.
Understanding the LED indicators
‘Power’ indicator: Indicator turn on indicate unit is ON.
‘Fault’ indicator: Indicator turns on indicate fault was detected. Unit has shutdown. To reset
unit, remove the fault condition and reset unit by using the toggle switch and
turn unit off and on again.
Understanding the fan operation
The fan on the unit will automatically turns on when it sense the internal temperature of the unit
reach to its preset level.
AC Load on Power Inverter
Although the Power Inverter can provide high surge power up to two times the rated output power,
some appliances may still trigger on the inverter protection system. A higher power inverter is
(11 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels